Peeling Under Eaves
 

Description:
Loss of adhesion of the paint film under eaves, porches or other protected areas where condensation is likely to form. Water-soluble chemicals in previously applied paint films contain salts which are pulled to the surface by moisture leaving a crystalline powder.

Possible Cause:
Lack of inter-coat adhesion can occur if:
- Paints are applied to old hard and glossy paint films.
- Salts which were formed during the life of the previous coat were not removed before the new coat of paint was applied. These salts form an invisible film, preventing a bond with a new topcoat. This leads to loss of adhesion and peeling. Eaves are protected areas which do not receive rain. Therefore, the natural cleaning effect of rain does not occur in these areas.

Solution:
Sand or wire brush the surface and wash all protected areas with a strong detergent solution and water. Rinse thoroughly with clean water and allow to dry.

Recommended System:
Primer
1 Coat of FLEX BON #169 Series Exterior Alkyd Primer
Topcoat
2 Coats of Top Quality FLEX BON Exterior Latex Paint